Equipment Upgrades
41
7 a. Remove the screw at the top of
the PARTNER ACS processor
module and remove the
module from the wall.
b. Mount the new PARTNER ACS
processor module by following
the instructions in
“Wall-Mounting a
Stand-Alone PARTNER ACS
Processor Module” and
“Inserting Batteries in the
PARTNER ACS Processor
Module” earlier in this guide.
c. Remount the top module by
following Steps 1 and 3
through 9 in “Wall-Mounting a
2-Slot Carrier and Modules”
earlier in this guide.
8 Connect the line and extension cords one at a time, making sure to place the
correct cords into their corresponding jacks on the new module. (See
“Connecting Lines and Extensions” earlier in this guide.)
9 Reconnect the power cord.
!
CAUTION:
The power cord should hang straight down from the connector, flush against
the plastic case for the entire length of the board. Do not install the power
cord at an angle to the case or with a loop in it.
P
ARTNER
3000
To Next Page
Loading...
