65
RAMBo
[R]epRap [A)]rduino-[M]ega compatible [M]other [Bo]ard. Designed by Joynnyr (Russell) of
UltiMachine.
Resolution
In general terms, the resolution you print at can be determined by the layer height you use.
The LulzBot Mini can print at layer heights of 0.05mm through 0.50mm with the standard tool
head.
Slic3r
Slic3r is a cross-platform 3D model slicing engine used to process a 3 dimensional model into
the GCODE (tool path) needed to physically generate the print.
Spool
Plastic filament coiled and stored on a plastic reel. 3mm filament is referred over 1.75mm fila-
ment due to improved feeding and better mounting options.
Thermistor
A special type of resistor that changes resistance based on temperature. It is used to measure
temperature on the nozzle and the heated bed.
Threaded extension
Used to separate the heater block and nozzle from the PEEK insulator. The plastic filament
passes through the threaded extension into the melting chamber.
To Next Page
Loading...
