Lumantek WEIVER 2.0 - WEIVER 2.0 Product Configuration

2.0 Player
/ Operations Manual
14
2.3 / Installation precautions
General Precautions
Power Precautions
AC Power
Log-o Caution
This section describes safety precautions that users shall be aware of during the system installation and operation.
Not complying such precautions may result in serious harm or personal injuries. . For that reason, please keep all
details here in mind before installing or using the WEIVER 2.0 Player.
Please carefully read the followings for safe use of Weiver 2.0 Player
- Must be operated and maintained free of dust or dirt.
- The cover should be securely fastened.
- Securely stow all the cables, external antennas, external SSD or any other tools away in a safe place after its use.
- Avoid wearing loose, draping clothing, and dangling jewelry when using WEIVER 2.0 Player.
- Do not open the WEIVER 2.0 Player case. Doing so may void the warranty and LUMANTEK takes no responsibility for
the damages caused by such action. Should you be experiencing performance issues, please contact your local dealer
for assistance.
- Make sure if it may cause overload in wiring when you connect the power source.
- Avoid wearing necklaces or watches when connecting the system to power source. These may cause electronic
shocks to the system.
- Avoid operating on a wet oor out in the open (e.g., raining). Make sure the power extension cable is in satisfactory
condition (e.g., not worn out).
- This unit comes with the AC power cord, grounding connection is necessary.
- In the event of a re, please disconnect the system from power source.
- Disconnect the system from power source before hardware installation, rub or contact on the
metal surface of the system to discharge statics from your body.
- Note: Manufacturer is not responsible for damages caused by using or replacing inappropriate
components or not authorized services.
- Supplying power during installation may cause serious damages to the system and personal
injuries.
Do NOT log o while “Remote Desktop “is running. You must shut-down the program by pressing
the close[x] button on top right. If you log-o the player, running program will be stopped and
“Please Wait”sigh will be appeared on front panel.
To recover from this state, you must log-on again after connecting the keyboard & monitor.