Using External DMX mode hands over all control to a third party DMX device. In this
mode the controller acts as a pass through DMX device and does not interfere with
the DMX data.
To regain control , exit this mode using the back button.
External DMX can also be used with the EOS controller in standby mode. However if
the controller is switched on and another function other than External DMX is selected
then the controller will take precedence and regain control.
For wiring installation of the third party DMX device see section 1.2
The EOS controller has built in sound to light capabilities. The lights can be setup to
synchronise their color change with the beat and frequency of the music.
The controller splits the audio input into low, mid and high frequencies. The color for
these frequency bands can be selected and changed. For best effect choose a different
color for each frequency band.
Press the select button to activate the Sound to Light mode. Hold down the select
button for 2 seconds to enter the adjust settings menu, which allows you to change the
colour bands, and back ground color of the Sound to Light function.
Adjust the sensitivity slider to compensate for variation in volume of the input music.
Choose a low sensitivity for quieter music and a high sensitivity for louder music. This
sensitivity will affect the response of the lights, set it to a level that obtains the desired
effect.
Note, if the input music is supplied by a stereo that does not a have a fixed line level
output then the sound to light sensitivity will be dependent on music volume. If little or
no lighting effect is observed ensure the volume of the stereo is turned up to a high
enough level.
To Next Page
Loading...