Installation Instructions
I - Sheet Number ASK05 Rev.-
Tools Required
Preparation Before Painting / Installation
• A trial fit is recommended to ensure proper positioning and fit.
• Check fit of parts before painting as we will not accept the return of modified or painted parts.
• Wash and dry your vehicle to remove any debris and/or dirt from the installation area.
NOTE: Ensure vehicle surface and part are between 60°F and 80°F (15°C and 27°C) prior to
installation.
80°F27°C
15°C 60°F
Do not drive vehicle for 24 hours after installation. Do not wash vehicle for 72 hours after installation.
LightShield
Clean Towel Masking Tape Wire Stripping Tool Grease Pencil Test LightCar Wash Supplies
Alcohol
Pad x6
Foam Tab
x1
Surface
Prep x1
Wire Stay
x8
Wire Connector
x4
Light strip
x1
Important Safety Information
• CAUTION - Before driving, ensure that the LightShield is properly secured to vehicle.
• Do not use automatic “brush-style” car washes.
• Do not use cleaning solvents of any kind.
• Periodically check all components for tightness.
NOTE: Actual product may vary from illustration.
Contents
For proper installation and best possible fit, please read all instructions BEFORE you begin.
For technical assistance or to obtain missing parts, please call Customer Relations at 1-800-241-7219.
Aeroskin LightShield Pro
™
Page 1 of 7
To Next Page
Need help?
General
