Lund REVOLUTION User Manual

I-Sheet Number I-20251 Rev.A
REVOLUTION BULL BAR
2007-CURRENT CHEVY SILVERADO1500/GMC SIERRA1500
2007-CURRENT TAHOE/SUBURBAN/YUKON/YUKON XL
2007-14 CADILLAC ESCALADE 1500/ESV/EXT
2007-13 CHEVY AVALANCHE
Page 1 of 7 11/21/16
PARTS LIST:
1
Bull Bar
6
12-1.75mm Nylon Lock Nut
1
Driver/Left Mounting Bracket
4
Bolt Assembly
1
Passenger/Right Mounting Bracket
1
LED Light Bar with mounting bolts
2
12x1.75mm x 30mm Double Bolt Plate
2
12 x 35mm Bolt Plate Single Bolt Plate
6
12mm x 24mm OD x 2.5mm Flat Washer
EQUIPMENT NEEDED:
• Safety Glasses
• Ratchet Set
• Pliers or Adjustable Wrench
IMPORTANT NOTES:
• Bull Bar may interfere with parking sensors on the bumper.
• The LED light bar can be wired into the factory light wiring or a wiring harness can be purchased separately.
• If state law requires a front license plate, a relocation kit is available separately.
• For cleaning, mild soap may be used to clean the Bull Bar, and aluminum polish may be used on the stainless
steel to polish small scratches and scuffs on the finish.
• REMOVE CONTENTS FROM BOX, VERIFY ALL PARTS ARE PRESENT, & READ INSTRUCTIONS
CAREFULLY. NOTE: PROFESSIONAL INSTALLATION IS RECOMMENDED.
Driver/Left
Mounting Bracket
(2) 12mm
x 35mm
Single
Bolt
Plates
(2) 12mm x
30mm Double
Bolt Plates
Passenger/Right
Mounting Bracket
(4) Bolt
Assembly

Lund REVOLUTION Specifications

General

Brand	Lund
Model	REVOLUTION
Category	Automobile Accessories
Language	English

Summary

Light Bar Installation

Bull Bar Installation

Tow Hook Removal Procedures

Detailed steps for removing tow hooks from the vehicle's front bumper area.

Bumper Preparation for Non-Tow Hook Vehicles

Modifying bumper inserts on vehicles without factory tow hooks for bracket clearance.

Mounting Bracket Installation

Installing the driver and passenger side mounting brackets onto the vehicle frame.

Bull Bar Attachment and Final Tightening

Securing the bull bar to the brackets and final hardware tightening.