Lund Ventvisor User Manual

Page 1 of 2
Installation Instructions
Contents - 2 Piece Set
Alcohol Pad x2
Front Driver
Side Visor
Front Passenger
Side Visor
I - Sheet Number LUNDVV153 Rev.A
For proper installation and best possible fit, please read all instructions BEFORE you begin.
For technical assistance or to obtain missing parts, please call Customer Relations at 1-800-328-2438.
Important Safety Information
• CAUTION - Before driving, ensure that the vent visor is properly secured to vehicle.
• Do not use automatic “brush-style” car washes.
• Do not use cleaning solvents of any kind.
• Periodically check all components for tightness.
NOTE: Actual product may vary from illustration.
Contents - 4 Piece Set
Front Driver
Side Visor
Front Passenger
Side Visor
Tools Required
Car Wash Supplies Clean Towel
Preparation Before Painting / Installation
• A trial fit is recommended to ensure proper positioning and fit.
• Check fit of parts before painting as we will not accept the return of modified or painted parts.
• Wash and dry your vehicle to remove any debris and/or dirt from the installation area.
Rear Driver
Side Visor
Rear Passenger
Side Visor
Alcohol Pad x4
Clip x4
Installation Steps
NOTE: Actual application may vary slightly from illustrations.
Clean window channel with alcohol pad. Remove tape liner from front & rear flanges. Peel back 2” of tape
liner from each end of top flange.
free end
top flange
rear
flange
front flange
Ventvisor
®
Deflector
1 2

Lund Ventvisor Specifications

General

Brand	Lund
Model	Ventvisor
Category	Automobile Accessories
Language	English

Summary

Important Safety Information

Safety Precautions

General safety warnings and cautions for vehicle accessory installation and use.

Contents - 2 Piece Set

Contents - 4 Piece Set

Tools Required

Preparation Before Painting / Installation

Pre-Installation Checks

Recommendations for trial fitting, checking parts before painting, and cleaning the installation area.

Installation Steps

Step 1: Window Channel Cleaning

Clean the window channel with an alcohol pad before applying the deflector.

Step 2: Adhesive Liner Removal

Remove tape liner from flanges and peel back 2" from top flange ends.

Step 3: Visor Insertion

Insert visor into window channel, front flange first, for rear visors.

Step 4: Seating the Visor

Hold visor up, pull bottom outward, and raise glass to seat visor properly.

Step 5: Clip Installation

Insert clips into window channel behind visor flanges for rear visors.

Step 6: Repeat for Passenger Side

Repeat installation steps 1 through 6 for the passenger side of the vehicle.

Care and Cleaning