5-4
CDA3000 Operation Manual
5 Diagnosis/Fault rectification
5.6 Reset The reset function is divided into two areas with differing effects.
Parameter reset restores to the last value stored in the device. Device
reset restores the entire data set to factory setting (delivery defaults).
Parameter reset with KEYPAD If you are in the setup mode of a parameter and press the two cursor keys
simultaneously, the parameter you are currently editing will be reset to the
last setting stored (= saved with parameter 150-SAVE).
Factory setting with KEYPAD Press both cursor keys simultaneously during inverter module power-up
to reset all parameters to their factory defaults and the system is
reinitialized.
Factory setting with
D
RIVEMANAGER
In the “Active device” menu, the “Reset to factory setting” option can be
used to restore the delivery defaults of the device.
Note: The factory setting causes application data set 1 (traction and
lifting drive, DRV_1) to be loaded. Check the terminal
assignment and functionality of the inverter module in this
operation mode, or load your own user data set.
To Next Page
Loading...
