Lust CDA34.017 - 4.2 Serial Commissioning

4-2
CDA3000 Operation Manual
4 Commissioning
4.2 Serial
commissioning
Apply this mode of commissioning when you want to commission several
identical drives (i.e. serial commissioning). The same inverter type and
the same motor must be used for each drive in an identical application.
If you already have a complete data set, skip the paragraphs headed
"Saving a data set to a SmartCard" (with KEYPAD) and "Saving a data set
from the device to a file"
(with DRIVEMANAGER).
4.2.1 Serial
commissioning
with K
EYPAD
Prerequisite:
• All inverter modules are fully connected.
• The first drive is already fully commissioned.
Attention: The CARD menu can only be selected when the drive is not
active!
Saving a data set to a
S
MART C ARD
Step Action Comment Display
1
Connect the KEYPAD to the inverter module of the
first drive, insert a S
MARTCARD and switch on the
power.
2
Choose the CARD menu.
= Load/save with
the S
MARTCARD
3
Choose WRITE. = Save data set
4
Choose ALL and
start the save operation with
the
Start/Enter key.
= Complete data set
is saved
5
READY appears.
= Save operation
completed without
error
By this action you have written your data set to a SMARTCARD.
CARD
CARD
CARD
CARD
CARD
start
enter
start
enter
start
enter
stop
return
stop
return