Lust CDD3000-HF - Push-through heat sink (Dx.x)

2-8
CDD3000-HF Operation Manual
2 Mechanical installation
2.5 Push-through
heat sink (Dx.x)
Step Action Comment
1
Mark out the positions of the tapped
holes and the breakthrough on the
backing plate.
Cut a tap for each fixing screw in the
backing plate and cut out the
breakthrough.
Dimensional drawings/hole
spacing see Table 2.5.
The tapping area will provide you
with good, full-area contact.
2
Mount the drive controller for high-speed
drives vertically on the backing plate.
Tighten all screws to the same tightness.
Pay attention to the mounting
clearances! The mounting seal
must contact flush on the surface.
3
Mount the other components, such as the
mains filter, line choke etc., on the
backing plate.
Mains filter max. 20 cm below the
drive controller for highspeed
drives
4
Continue with electrical installation in
section 3.
Note the following points:
• Distribution of power loss:
• The all-round mounting collar must be fitted with a seal. The seal
must fit flush on the surface and must not be damaged.
(1) Seal
(2) Tapped hole for
EMC contact
(3) Outside
(4) Inside
• The backing plate must be well grounded.
• The best result for effective EMC installation is attained with a
chromated or galvanized backing plate. If backing plates are
varnished, the coating must be removed in the area of the contact
surface!
BG3 BG4 BG5
Power loss
Outside (3) 70% 75% 80%
Inside (4) 30% 25% 20%
Protection
Heat sink side (3) IP54 IP54 IP54
Machine side (4) IP20 IP20 IP20
;;yy
;;yy
(4)
(3)
X5
X6 X7
;y
(1)
(2)