4-4
CDD3000-HF Operation Manual
4 Commissioning
4.2.2 Serial
commissioning
with K
EYPAD
Note: Serial commissioning with KEYPAD is not possible with a
position controlled preset solution.
Precondition:
• All CDD3000-HF drive controller are fully connected.
• The first drive is already fully commissioned.
Attention: The CARD menu can only be selected when the drive is not
active!
Saving a data set to a
S
MARTCARD
Step Action Comment Display
1
Connect the KEYPAD to the CDD3000-HF of the first
drive, insert a S
MARTCARD and switch on the power.
2
Press stop/return twice to
call up the CARD menu.
= Load/save with
the S
MARTCARD
3
Choose WRITE. = Save data set
4
Choose ALL and
start the save operation with
the start/enter key.
= Complete data set
is saved
5
READY appears.
= Save operation
completed without
error
By this action you have written your data set to a SMARTCARD.
CARD
CARD
CARD
CARD
CARD
start
enter
start
enter
start
enter
stop
return
stop
return
To Next Page
Loading...