CDD3000-HF Operation Manual
Appendix B Index
A-21
DE
EN
FR
IT
ES
FR
1
2
3
4
5
A
Appendix B
Index
A
Air humidity, relative .............................. A-8
Ambient conditions
............................... A-8
Ambient temperature
............................. 2-7
B
Braking chopper ................................. 3-16
Braking resistor (RB)
............................. 3-16
Breakthrough for push-through heat sink
....... 2-9
C
CARD menu ...................................... 4-25
Change in system load
.......................... A-10
Cold plate
......................................... 2-5
Connecting cable
................................. 2-6
Connection
Braking resistor
............................. 3-16
Servocontroller
.............................. 4-22
Connection of the temperature sensor
........... 3-7
Control connections
.............................. 3-17
Cooling
Motors / Motors with external ventilation
.. 3-13
Required with cold plate
..................... 2-7
Current capacity
.................................. A-4
D
Dangers ........................................... 1-1
Data set
Loading into next servocontroller
............ 4-5
Saving to a SmartCard
....................... 4-4
DC link
............................................ A-11
Diagnosis/Fault rectification
...................... 5-1
Digital scope function
............................ 4-19
Dimensional drawings
Push-through heat sink
..................... 2-10
Wall mounting
................................ 2-4
Dimensional drawings: cold plate
................ 2-6
Disconnect
........................................ 4-3
DriveManager
.............................. 4-9, 4-22
E
Electrical specification ................... 3-24, 3-27
EMC (Electromagnetic Compatibility)
............ 1-1
EMC-compatible installation
..................... 2-3
Emergency Stop facility
........................... 1-2
Encoder connection
.............................. 3-13
Encoder simulation
.............................. 3-23
Master encoder input
....................... 3-23
Encoder simulation connection and signal description
3-24
Encoder simulation signals
...................... 3-23
ENPO
............................................. 4-19
Error messages
................................... 5-3
Errors in power switching
........................ 5-5
Errors, resetting
................................... 5-4
F
Factory setting .................................... 5-6
Fault response
.................................... 5-2
Feather key
....................................... 4-18
Functions of the menus
.......................... 4-24
G
Grounding lead
connection
.................................... 3-4
Star configuration
............................ 3-4
H
Hall-IC encoder .................................. 3-12
Helpline
............................................ 5-3
HTL master encoder
............................. 3-27
I
Icon ............................................... 4-22
Intended use
...................................... 1-2
Interference emission
............................. 3-3
Intermittent
........................................ A-4
Isolation
.......................................... 3-21
To Next Page
Loading...