Page 4
Page 17
Need help? Call the Lutron Technical Support Center, 24/7 at 800.523.9466
Installing Your Dimmers
Installing an AuroRa dimmer is as straightforward as replacing a light switch.
Your first step is to identify how many switches control the lights you
have decided to add to your system.
This is important so that you use the correct installation instructions.
Lutron has created specific instructions for lights controlled by one, two,
or three switches to help simplify your installation.
After you have installed the first dimmer, repeat the process until all of the
AuroRa dimmers have been installed.
If this is your first time wiring a dimmer, we recommend that you read over
the dimmer information found on page 18 before proceeding. If you have any
questions, give our 24/7 Technial Support Center a call at 800.523.9466.
Use dimmers with 120V incandescent lighting fixtures only. Do not use
with low-voltage transformers.
The total wattage of all light bulbs controlled by each dimmer must be
between 50 and 600 watts.
When combining dimmers in the same wallbox, the dimmer’s load capacity
must be reduced.
Note:
Need help? Call the Lutron Technical Support Center, 24/7 at 800.523.9466
Frequently Asked Questions
Will other equipment in
my home or neighboring
homes interfere with my
AuroRa
® system?
How far away can I use
my wireless controller?
100 feet typically in any direction
from the central antenna
RF Co
mmunication
System Visor
Adv
anced
Bridge Add
Power
The central antenna has a radio frequency range of at least 30 feet in
any direction.
AuroRa
® operates at a frequency different from most remote controls,
cellular/portable phones, and other wireless devices. The communication
protocol ensures that any device operating at the same frequency will not
affect your system.
AuroRa has non-volatile memory that maintains all system addressing
and master control programming during a power outage. After the power
outage, the memory restores all system lighting to its previous state
before the power failure.
Yes. One or all of the dimmers can be relocated to different locations
in the home, if the user prefers to control different lights. All system
addressing, as well as master control and wireless controller
programming remains unchanged.
You can increase the capability of your AuroRa system by adding
another complete package or by adding up to nine additional
wireless controllers. (See “Bridging AuroRa Systems” on page 15)
No. AuroRa dimmers work with standard 3 or 4-way switches. Only one
AuroRa dimmer can be used to control a light or group of lights.
What is the range of the
central antenna?
What happens to the
AuroRa system during a
power outage?
Can I replace or move a
dimmer after the initial
installation?
Can I add to my AuroRa
system?
Can I use two AuroRa
dimmers to control a light
or a group of lights?
To Next Page
Loading...
Need help?
General
