5)After finish the " High limit value " adjustment,
press the " Enter Button " ( 5-4, Fig. 1 ) will save the
high limit value and going to adjust the alarm
Hysteresis value, procedures will similar as above.
Upon finish the alarm " Hysteresis value " adjustment,
press the " Enter Button " ( 5-4, Fig. 1 ) will save the
data.
6)Press the " ESC Button " ( 5-3, Fig. 1 ) to finish
alarm setting procedures.
7-6 Data hold
During the measurement, press the " Hold Button " ( 5-3,
Fig. 1 ) once will hold the measured value & the LCD will
inducate a " HOLD " symbol.
Press the " Hold Button " once again will release the data
hold function.
7-7 Data Record ( Max., Min. reading )
* The data record function records the maximum and
minimum readings. Press the " REC Button " ( 5-4, Fig.
1 ) once to start the Data Record function and it
will be a " REC " symbol on the display.
* When the " REC " symbol on the display :
a)Press the " REC Button " ( 5-4, Fig. 1 ) once, the
" REC MAX " symbol along with the maximum value
will appear on the display.
Press the " REC Button " ( 5-4, Fig. 1 ) once again, the
" REC MIN " symbol along with the minimum value.
If intend to delete the maximum ( Minimum ) value,
just press the " Hold Button " ( 5-3, Fig. 1 ) once,
then the display will show the " REC " symbol only &
execute the memory function continuously.
b)To exit the memory record function, just press the "
REC Button " 5-4, Fig. 1 ) 2 seconds continuously at
least. The display will revert to the current reading.
11
To Next Page
Loading...
