Step by Step instructions for GRAFIK Eye Dimming Panel
22
Wallstations and
Control Interfaces
STEP 19: Set Up Wallstations
All Wallstations (except NTGRX-1S) must be set up to make a
Control Unit(s) “listen” to button presses on the Wallstation.
■ Only one Wallstation can be set up at one time.
■ A Control Unit can also be made to “listen” to another Control
Unit and is therefore listed with the Wallstations below.
Follow the following chart for each Wallstation.
Notes:
■ Wallstations cannot be made to “listen” to each other, but a
GRX-4000 Series Control Unit can be made to “listen” to more
than one Wallstation.
■ When it is desired for two GRX-4000 Series Control Units to
always respond to each other’s button presses, the first Control
Unit must be set-up to respond to the second Control Unit’s
buttons, and then the second Control Unit must be set up to
respond to the first Control Unit’s buttons.
■ An NTGRX-1S is wired directly to the GRX-4000 Series Control
Unit that is to “listen” to it. No setup is required.
■ GRX-PRG and GRX-RS232 do not require this setup.
Control
(only 1 at a time)
GRX-4000
Series Control
Unit
NTGRX-4S
NTGRX-4S-IR
GRX-4S-DW
EGRX-4S
EGRX-4S-IR
EGRX-8S
EGRX-8S-IR
GRX-CIR
w/GRX-IT/81T
NTGRX-4B
NTGRX-4PS
NTGRX-4M
NTGRX-2B-SL
EGRX-2B-SL
Partition
Status Control
NTGRX-2B-SL
EGRX-2B-SL
all other
functions
GRX-AV
Place Control to
‘Talk’ in Set-Up Mode
Press and hold first and the fifth buttons of the GRX-
4000 Series Control Unit.
Press and hold first and fifth buttons on Wallstation
until its LEDs cycle sequentially.
Note: GRX-CIR only has 1 LED. Use the GRX-IT to
press the first and fifth buttons.
Press and hold first and fourth buttons on
Wallstation until its LEDs cycle sequentially.
Press and hold first and fifth buttons until LED 1
blinks.
Press and hold first and fifth buttons until LED 1
blinks.
Press and hold both buttons of the NTGRX-2B-SL or
EGRX-2B-SL until its LEDs blink.
Press and hold both buttons of the NTGRX-2B-SL or
EGRX-2B-SL until its LEDs blink.
Press and hold the Program Switch until its LEDs
react like the Wallstation whose function is being
simulated.
To Next Page
Loading...
