Lutron Electronics Maestro MS-OPS6-DDV - User Manual

Maestro® Dual-Circuit Occupancy Sensing Switch
Additional Programming, Installation, and Troubleshooting Help
Application Note #489
Revision A
July 2013
1 Technical Support — 800.523.9466
MaestroR Dual-Circuit Occupancy Sensing Switch Models
MS-OPS6-DDV; MS-PPS6-DDV
Overview
This document serves as a supplement to the Maestro® Dual-Circuit Occupancy Sensing Switch instruction sheet.
Note: For performance specifications, see the Dual-Circuit Occupancy Sensing Switch spec submittal (P/N 369748) at
www.lutron.com/occvacsensor
Dual-Circuit Occupancy Sensing Switch
(shown without faceplate)
Circuit 1 Tap Button
Circuit 2 Tap Button
Top Programming Button
Bottom Programming Button
Glossary ................................................................Page 2
Explanation of Sensing Switch Features ............Page 3
Sensing Switch Coverage Area .......................... Page 6
Sensing Switch Programming ............................Page 7
Additional Programming Options .......................Page 9
Restoring Default Settings .................................. Page 9
Wiring Diagrams ................................................. Page 10
Ambient Light Detect (ALD) -
How it Works .......................................................Page 11
Troubleshooting .................................................. Page 13
WARNING! Shock Hazard. May result in serious injury or death. For bulb replacement or rewiring, power MUST be
disconnected at the main electrical panel

Lutron Electronics Maestro MS-OPS6-DDV Specifications

General

Model Number	MS-OPS6-DDV
Brand	Lutron Electronics
Type	Occupancy Sensor Switch
Voltage	120 VAC
Sensor Type	Passive Infrared (PIR)
Mounting Type	Wall Mount
Ambient Light Level Adjustment	Yes
Operating Temperature	32°F to 104°F (0°C to 40°C)
Neutral Wire Required	No
Color	White
Load Type	Incandescent, Halogen, CFL, LED
Adjustable Time Delay	Yes
Warranty	1 Year
Installation	existing wiring
Maximum Load	600W Incandescent/Halogen, 300W MLV, 250W ELV, 150W LED/CFL
Wattage	600W Incandescent/Halogen, 300W MLV, 250W ELV, 150W LED/CFL

Summary

Glossary

Explanation of Sensing Switch Features

Timeout

Approximate time lights stay on after last motion detected. Adjustable 1-30 minutes.

Sensor Mode

Controls how lights respond to initial occupancy (Auto-ON or Manual-ON).

Advanced Auto-ON Mode

Customizes Auto-ON response to daylight and occupancy situations.

Sensitivity

Adjusts sensor's sensitivity to detect motion, default is High-Sensitivity.

Zone Mapping

Option to swap assignments of lighting zones (Circuit 1 and Circuit 2).

Sensing Switch Coverage Area

Dual-Circuit Sensing Switch Programming

Selecting a Timeout Duration

Procedure to adjust the Timeout setting for each circuit using Tap buttons.

Selecting a Sensor Mode

Procedure to select Auto-ON/Auto-OFF or Manual-ON/Auto-OFF for each circuit.

Selecting Advanced Auto-ON Mode

Procedure to set advanced Auto-ON modes like ALD, OWO Enabled/Disabled.

Selecting the Sensitivity

Procedure to adjust sensor sensitivity or restore all settings to default.

Additional Programming Options

Swapping Zone Assignments

How to swap the button assignments and functionality of Circuit 1 and Circuit 2.

Restoring Default Settings

Procedure to return all settings to the original factory defaults.

Wiring Diagrams

Ambient Light Detect (ALD) - How it Works

Troubleshooting