Lutron Electronics RADIO RA2 User Manual

24/7 Technical Support—800.523.946628
|
Lutron®
programming shortcuts
copy button programming
Any previously programmed Keypad button in a Keypad column
can be copied to another Keypad button. A Keypad button can be
copied to a Keypad button on the same Keypad or to a Keypad
button on a different Keypad. Buttons in a "Shade" Keypad column
can not be copied.
Note: Prior to copying Keypad buttons, make sure to enter and
exit Program Mode at least once on each Keypad that you will be
copying to. See steps 1 and 7 of programming buttons.
1. Enter Program Mode on a previously programmed Keypad
Press and hold the top and bottom buttons
of the rightmost column (top 2buttons on
RRD-W2RLD Keypad and VCRX Keypad column)
for 3seconds until the top button LED begins to
normal-flash.
2. Press and release the previously
programmed Keypad button to be copied
3. Paste programming to a new Keypad button
Press and hold the new Keypad button for
6seconds until the new Keypad button LED
rapid-flashes for 2 seconds.
After 2 seconds, the “pasted to” Keypad button
LED will normal-flash. The “pasted to” Keypad
is now in Program Mode and the “copied from”
Keypad has exited Program Mode.
Note: To copy additional programming, repeat
steps 2 to 3.
4. Exit Program Mode
Press and hold the top and bottom buttons
of last Keypad "pasted to" for 3 seconds until all
LEDs rapid-flash.

Lutron Electronics RADIO RA2 Specifications

General

Brand	Lutron Electronics
Model	RADIO RA2
Category	Remote Control
Language	English