Lutron Electronics RADIO RA2 User Manual

www.lutron.com/radiora2 Lutron®
|
35
resetting devices to factory settings
Resetting a device to factory settings will remove it from the system
and will clear its programming. After being reset to factory settings,
the device will need to be reprogrammed as part of a RadioRA
®2
system. To reset a device to factory settings, perform the steps below.
Dimmer, Switch, Keypad, Visor Control Receiver,
Pico
®Wireless Control, Triathalon® Shade, or Repeater
1. Triple tap and hold any button* on the device.
DO NOT release the button after the third tap.
2. Keep the button pressed on the third tap until...
A. Dimmer: the Dimmer LEDs ramp up and down
rapidly and the load flashes at the same rate.
B. Pico
® Wireless Control: 6 to 8 seconds.
C. All other devices: the LED(s) start to rapid-flash
(approximately 3seconds).
3. Release the button and immediately (within
1/2 second) triple tap it again. Dimmers and
Switches will normal-flash their loads. All other
devices will rapid-flash their LED(s) again. When
the load(s)/LED(s) stop flashing, the device has
been reset to factory settings.
* Except raise, lower, or learn.
3X
+
hold
3X
LUTRON
Setup
Wired
RF
Communication
Repeater Status
1
3
4 2
M
Power
Repeater Link
COM
9 V
1
N / C
MUX
MUX
2
3
4
AddTest
USB
Integrate Program / Integrate
RS232
Ethernet
Main Repeater
Shade
Open
Close

Lutron Electronics RADIO RA2 Specifications

General

Brand	Lutron Electronics
Model	RADIO RA2
Category	Remote Control
Language	English