Lutron Electronics RADIO RA2 - programming vcrx; programming buttons

www.lutron.com/radiora2 Lutron®
|
39
Symptom Possible Cause Remedy
Programming Buttons
After entering Program
Mode, LEDs on a
Keypad, Dimmer/
Switch, or other device
are not normal-flashing.
Device has not been
assigned to a button.
Assign the device to
a button following the
instructions starting at
step2 in programming
buttons.
When attempting to
assign a Dimmer/Switch
to a Keypad button, the
load connected to the
Dimmer/Switch does
not turn on/off 3 times
and the LED(s) do not
normal-flash.
Dimmer/Switch has
not been added to the
system.
Add the Dimmer/Switch
to the system following
the steps in adding
auxiliary repeaters
and devices.
Programming VCRX
After entering Program
Mode, LEDs on a
VCRX, Dimmer/Switch,
or other device are not
normal-flashing.
Device has not been
assigned to a VCRX
button.
Assign the device to a
VCRX button following
the instructions
starting at step2
in programming
buttons.
device troubleshooting