Lutron Electronics Switch - Panel with Isolation Switch Wiring

R
12 Installation Guide for Switching Panels
Wiring
(continued)
L
SL
N
L
SL
N
L
SL
N
L
SL
N
Panel with Isolation Switch: Feed and Load Wiring
(230/220-240 V only)
Bypass jumpers -
do not remove
Load
Ground bus
Main feeds:
Phase A, B, C, and Neutral
Wiring Tips
• Wire the switching panel similar
to wiring a lighting distribution
panel.
• Run feed and load wiring. No
other wiring or assembly
required.
The switching panel can provide
temporary lighting:
• Wire all loads.
• Leave the bypass jumpers in
place.
• Use branch circuit breakers at
the distribution panel to switch
lights on and off.
Wire Sizes
230 V #14-#2 AWG (2.0-35 mm
2
)
220-240 V #14-#10 AWG (2.0-4.0 mm
2
)
Switched Hot/Live
#14-#10 AWG
(2.5-4.0 mm
2
)
Load Neutral
#14-#10 AWG
(2.5-4.0 mm
2
)
Typical
switch leg