Lutron Electronics YK-2001PHA - Function Selection

4. FUNCTION SELECTION
1) Turn on the meter by pressing the " Power Button "
( 3-2, Fig. 1 ) momentarily.
*
Pressing the " Power Button " ( 3-2, Fig. 1 )
continuously and > 2 seconds again will turn off the
meter.
2) The meter can select 7 kind Function as :
a. pH measurement
b. mV ( ORP ) measurement
c. Dissolved Oxygen measurement
d. Air Oxygen measurement
e.
Conductivity measurement
f.
TDS measurement
g. Salt measurement
Use the " Function Button " ( 3-6, Fig. 1 ) Key to select intent test
function. Display will show the following text in sequence :
PH
pH measurement
OrP
mV ( ORP ) measurement
do
Dissolved Oxygen measurement
O2 Air Oxygen measurement
Cd
Conductivity measurement
tdS
TDS measurement
SALt Salt measurement
Until the Display show the desired mode the meter will
execute this Function with default.
12