6) Display will show the Dissolved Oxygen values ( mg/L )
at the same time the bottom display will show the Temp.
value of the measured solution.
7) Rinsed the probe accurately with normal tap water after
each series of measurement.
Oxygen in the air
Use the " Function Button " ( 3-6, Fig. 1 ) Key, select to
O2 measurement Function.
the Display unit will show " %O2 ",and show the air Oxygen value
for reference.
Change the Temp. unit to ℉
If intend to change the Temp. unit from ℃ to ℉,
please refer to chapter 10-3, apge 34.
"% Salt" compensation value adjustment
If intend to change the % Salt compensation value,
refer chapter 10-4, page 34.
"Height" compensation value adjustment
If intend to change the Height compensation value,
refer to chapter 10-5, 10-6, page 34 page 35.
27
To Next Page
Loading...
