52
- Left button and button adjust the movement of the left bar while button of the right
side and button adjust the movement of the right side bar.
- Measurement value is indicated on the monitor.
- Measurement value is saved automatically.
- Measured value gets indicated at the Pupil Size at the screen’s center lower part. Average of the
recent two measurement values is indicated in the “Avg Size” below.
- Stopped screen is undone when you press on the measurement button.
5. Measurement repetition
- It is possible to measure up to two measurement values when the measurement is repeated. Repeat
the operation of 2 ~ 5 when measuring again.
6. Measurement of the eye on the opposite side
- Measure the eye on the opposite side using the same method after moving the stage to the opposite
side.
7. Measurement result output
- Cornea diameter measurement result is output as the “[PUPIL SIZE]” category by the built-in printer.
To Next Page
Loading...