L98005G3-EU-A 9
User Manual: PCD-51™ 731A
6. Starting the Treatment Session
Now you are ready to operate the console and begin your treatment.
Note:
Hold the console handle with one hand while turning On / Off
the Power Switch with your other hand.
1. Ensure that all hoses are properly connected to the garment and that
the hose bundle is securely attached to the console.
2. Verify that the Power Switch at the back of the console is in the OFF
position.
3. Connect the DC power adapter cable to the DC adapter socket
(located under the Power Switch).
4. Connect the DC power adapter to the electrical outlet.
5. Get into a comfortable seated, reclining, or lying position from where
you can easily reach the console controls. Put on the garment,
following the directions in Section 3.3 above.
6. Turn the Power Switch to the ON position.
7. Press .
Treatment begins.
Note:
At the start of treatment, the garment may take several inflation
cycles to fill completely, as the garment must be filled from a
completely empty state.
7. Ending the Treatment Session
1. When your treatment time is complete, treatment stops.
If you need to stop treatment in the middle, press .
At the end of treatment, turn OFF the Power Switch.
2. When treatment stops, wait up to 30 seconds to allow the garment to
deflate before you remove it.
Note:
When immediate garment deflation is necessary, disconnect the
hose bundle from the console to immediately deflate the air
pressure in the garment.
To Next Page