Lynx 2000 Forest Fox Syncro - Driving; Starting the Cold Engine

22
OPERATORS MANUAL
DRIVING
Important! Always check before starting:
· That the throttle and brake levers run smoothly and return to
basic position immediately after the grip is loosened.If not,
repair!
· That there is not ice or snow in the boggie, and that the track
has not frozen in the ground (lean the snowmobile).
· That all the covers are in there positions and the engine cover
is closed.
· Fasten the rope of the emergency switch on your right wrist or
to your clothing. At the same time check that the
emergency switch is not in short circuit.
· Check before driving that engine will stop when the emergency
switch is pulled off.
· Set the gear in neutral.
· Clean and check operation of the lights.
· Before driving check that the engine is stopped when the
emergency switch lock is pulled off.
STARTING THE COLD ENGINE
· Turn the ignition switch to on position turn until engine start.
· Pump with the primer 23 times.
· Turn the choke lever to upright position and further to max.
position.
· Pull smoothly the slack from the starter rope, and then pull
strongly. Return the rope by holding the handle. Faulty
proceeding may damage the starter.
· Turn the choke lever to upright position when the engine runs,
and turn the lever off when the engine has warmed up.
NOTE: If the engine is warm there is no need to use the primer. If
engine only ignites after two or three attempts, pump
once with the primer and start the engine.