Lynx Forest Fox Syncro - Starting the cold engine

OPERATORS MANUAL ____________________________________ 17
ENGLISH
Starting the cold engine
NOTE! Do not use gas together with choke.
Turn the ignition switch to the position 2. Start engine.
As soon as engine is running, turn the switch to position 1.
After few seconds turn the switch to position OFF.
NOTE! On very cold weather, for example. colder than 20ºC, choke may have to be used
few times on position 1, until engine runs smoothly.
NOTE! In case the snowmobile is equipped with DESS (Digitally Encored Security System)
but there is no electrical starter, ignition switch does not exist. DESS system(Sport/Touring
family) in RAVE, Enduro 500/600/700, S-Touring 500/600/700. Key switch we have in
models with el.starter (S-Touring 500/600). Other models have only DESS switch. We
have 8 hours break-in period in models mentioned above.
These models have an initial build system, which isnt giving out engines maximum power
before engines 8 hours break-in period is past.
DPM system we have in Rave 800.
DESS (Digitally Encoded Security System)
This system is a deterrent against theft. The tether cord provided with your snowmobile is
LYNX dealer programmed and is the one that allows engine to turn more than 3000 RPM.
If an incorrectly programmed tether cord is installed the engine can not reach engagement
speed required to move vehicle.
1.OFF
2. Position 1
3. Position 2