Lynx Forest Fox Syncro - STOPPING THE ENGINE;TETHER CUT-OUT SWITCH

18 _____________________________________________ OPERATORS MANUAL
ENGLISH
MODELS WITH MANUAL STARTER
Apply key to ignition swithc and turn it ON position.
Pull smoothly the slack from the starter rope, and then pull strongly. Return the rope by
holding the handle. Faulty proceeding may damage the starter.
NOTE: Do not apply gas when starting.
STARTING WITH ELECTRIC STARTER (some models)
Turn the key in ignition switch to clockwise direction, until starter engages.
Release key immediately when engine has started.
NOTE: If electric starter for some reason can not be used, apply key to ON position and
use manual starter.
WARNING!
Electric start models only: never charge or boost battery while installed on
snowmobile.
STOPPING THE ENGINE/TETHER CUT-OUT SWITCH
Engine stops when the ignition key/the stop button is turned into STOP-position or when
the emergency switch lock is pulled off or when the emergency switch on right handle is
pushed down.
WARNING!
The snowmobile engine can be stopped by activating the emergency cut-out button,
pulling the tether cord or turning the key.