Lynx Forest Fox Syncro - Track Tension and Alignment; Track adjustment

OPERATORS MANUAL ____________________________________ 41
ENGLISH
TRACK TENSION AND ALIGNMENT
NOTE: We recommend you to visit authorized LYNX-service point for checking track tension.
They use belt tension tester (P/N 414 348 200).
A belt tension tester may be used to measure deflection as well as force applied.
Belt tension tester (P/N 414 348 200)
1. 7,3 kg
2. Deflection
Track adjustment
NOTE: Ride the snowmobile in snow about 15-20 minutes prior to adjusting track tension.
Lift rear of snowmobile and support it with a snowmobile mechanical stand.
Allow the suspension to extend normally and check gap half-way along slider shoe.
The gap should be as given in the specification section of this guide.
If the track tension is too loose, track will have tendency to thumb.