13
STO-ST9 The status 0-9 keys are used to send pre-programmed status
message to the EDACS site.
PVT Enables or disables Private Mode for the System/Group
displayed. See the PRIVATE OPERATION section.
KEY Displays the Encrypted Keys. This selects the DISP KEY
operation from the menu functions.
G* This key function is used in Conventional Mode to send
G-STAR™ emergency signaling.
PA This key function enables and disables the Public Address
feature.
# DTMF keypad function.
1-9 Keypad numbers.
* DTMF Keypad function.
Primary Functions (Quick Access)
The secondary function of the k button is to toggle the keypad buttons
between their primary function and their secondary function. When the
secondary keypad is active, i.e. entering phone digits for an interconnect call,
the
k button can be used to toggle the keypad buttons back to their primary
function, perform a task (siren/light enable), and then toggle back to finish
entering the digits for the phone number. PRIMARY is displayed when the
k button is used to toggle the keypad keys back to their primary functions.
This provides quick access to the primary functions of the keypad. This is a
programmable feature of the
k button only. Careful consideration should be
given to possible operational conflicts before enabling this feature.
Several keys on the Scan version have a secondary function. The
m key is
the SELECT secondary function with the
C key remaining the same for the
secondary function. On the system version, the
o has a secondary function
for DELETE,
m is SELECT and c retains its CLEAR function.
To Next Page
Loading...
