M/A-Com Orion - Adding Groups to a Scan List; Deleting Groups from a Scan List

39
Adding Groups To A Scan List
1. With scan operation turned OFF, select the desired group to add to the
selected Trunked system group scan list.
2. Press < or > on the SCAN add/delete control. The current priority
status of the group will be displayed in column 1 of line one for a time-out
period. If the group is not part of the scan list the status will be blank.
3. While the status is displayed press < to add the group to the scan list.
"S" is displayed on line one.
4. Press < a second time to set the group to Priority 2. A "2" is displayed
on line one.
5. Press < a third time to set the group to Priority 1. A "1" is displayed on
line one. The priority level selection sequence only advances the group to
next higher priority level and stops at priority level 1. To select a lower
priority level, the group must be deleted from the scan list and then added
back to the scan list. Each new group added to the scan list starts at the
lowest priority. If the the Priority 1 and Priority 2 groups are already set
and a new group is assigned as Priority 1 or Priority 2, the previously
assigned group will change to non-priority scanning.
Deleting Groups From A Scan List
1. With scan operation turned OFF, select the desired group to delete from
the selected trunked system's group scan list.
2. Press < or > on the SCAN add/delete control. The current status of
the group is displayed for a time-out period.
3. Press > to delete the group from the scan list. "S," "2," or "1" turns
OFF. Any group that is not in a trunked system group scan list will show a
"blank" for the time period when it is the selected channel.
Nuisance Delete
A group can also be deleted from the scan list, if it is not the currently selected
group, by pressing > twice during scan operation while the radio is
displaying the unwanted group. The group will be deleted from the system's
group scan list in the same manner as if done using the steps above. Deletions
done in this manner will not remain deleted if the radio is turned OFF and then
back ON.