15
MESSAGES
During radio operation, various messages are displayed on either line one or
line two. Typical messages include control channel status information, such as
system busy or call denied, or messages associated with the radio's operation,
(i.e. volume adjust). These messages are described as follows:
MESSAGE NAME DESCRIPTION
QUEUED
Call Queued Trunked mode only. Indicates the system has
placed the call in a request queue.
SYS BUSY
System Busy Trunked mode only. Indicates the system is
busy, no channels are currently available, the
queue is full or an individual call is being
attempted to a radio that is currently
transmitting.
DENIED
Call Denied Trunked mode only. Indicates the radio is not
authorized to operate on the selected system.
CC SCAN
Control Channel Scan Trunked mode only. Indicates the control
channel is lost and the radio has entered the
Control Channel Scan mode to search for the
control channel.
WA SCAN
Wide Area Scan Trunked mode only. Indicates the control
channel is lost and radio has entered the Wide
Area Scan mode to search for a new system
(if enabled through programming).
TALKARND
Talk-around Conventional mode only. Indicates the radio
is operating on conventional channels in talk-
around mode (no repeater).
*RXEMER*
Receive Emergency Trunked mode only. Indicates an emergency
call is being received. This message will be
flashing on line two.
*TXEMER*
Transmit Emergency Trunked mode only. Indicates an emergency
call has been transmitted. This message will
be flashing on line two.
VOL=31
Volume Level Indicates the current volume level. The
volume level display ranges from OFF
(silent) to 31 (loudest).
UNKNOWN
Caller's ID Not
Received
Indicates that an individual call is being
received, but the caller's ID was not received.
TX DATA
Transmit Data Trunked mode only. Indicates the radio is
transmitting a data call.
RX DATA
Receive Data Trunked mode only. Indicates the radio is
receiving a data call. Displayed on line 2.
DATA OFF
Data OFF Trunked mode only. Indicates radio is in the
data disabled state. Displayed on line 1.
To Next Page
Loading...
