Turning Scan ON
1. Toggle scan operation by pressing k. The SCAN indicator will turn on
when the radio is scanning.
NOTE
The k key light will blink when temporarily
disabled.
Scanning will stop while microphone is OFF-hook if
hook switch feature is enabled through programming.
2. When a group on the scan list receives a channel assignment, the radio un-
mutes on the assigned channel, BSY indicator comes on and the received
scan group is displayed.
• The radio will continue scanning if a new group is selected when
scan is on.
• Pressing the PTT button when scan is on will cause the radio to
transmit on the displayed group or to the currently selected group
depending on programming.
• Pressing < when scan is on will cause the radio to recall the
scanned group that was last received. This group is recalled for a
period equal to the scan hang time.
Priority Group Scanning
When scan is enabled and the Priority 1 and Priority 2 groups have been
identified, the radio will listen to calls on those groups and the selected group.
While receiving a scanned group call, the radio will continue to monitor the
selected, Priority 1 and Priority 2 groups and will drop the call if the selected
group or other higher priority call becomes active. During a Priority 2 call the
radio will continue to monitor for a Priority 1 group call.
The radio will monitor for Agency and Fleet calls which correspond to the
Agency and Fleet associated with the Priority 1 and Priority 2 groups. Priority
Agency and Fleet calls will be indicated by displaying AGENCY or FLEET
on the System line of the display and associated Priority 1 or 2 group on the
Group line of the display.
Turning Scan OFF
Toggle scan operation OFF by pressing k. The radio will resume
operation on the selected group.
40
To Next Page
Loading...
