M.D. Resource K Pump - Troubleshooting; Common Issues and Solutions

198-003 K Pump IFU Rev D 15
Chapter 8: Troubleshooting
This chapter contains information about troubleshooting your K Pump.
 The following table describes some of the most common troubleshooting options for the K
Pump:
Topic
Possible Cause
Possible Solution
Pump not operating
Power Switch not “ON”.
Turn Power Switch “ON”
Power Adapter not plugged
into wall outlet.
Plug Power Adapter into
outlet.
Power Adapter not plugged
into unit.
Plug Power Adapter into
Power Inlet. Depress Foot
Pedal.
Foot Pedal not activated.
Depress Foot Pedal.
Foot Pedal(s) do not
activate the Pump.
Foot pedal cable not
connected.
Connect Foot Pedal cable to
the Bulkhead Connectors.
Foot pedal broken or torn
Replace Foot Pedal.
Power Switch not “ON”
Turn Power Switch “ON”
Pump does not start when
Foot Pedal is depressed.
Fluid flow is too low`.
Increase the speed by
turning the control knob
clockwise.
Wrong tubing in Pumphead
Contact M.D. Resource. to
obtain proper tubing for the
unit