198-003 K Pump IFU Rev D 12
- Obtain the LS2 “Hospital Grade” Universal power cord and insert one end to the LS2 and
the other end to wall socket.
Note: Refer to your LS2 User & Technical Manual for further instructions on how to set-up your
aspirator.
o To Tumescent Measuring Device, TMD
- Perform “Connecting Standard Accessories” Steps 1 to 3 (Page 10).
- Obtain the Conductor Cable and insert one end into the TMD and the other end into one
of the Power Inlets of the K Pump.
Note: Refer to your TMD User Manual for further instruction on how to set-up your tumescent
measuring device.
Note: For safety, only use the specified parts supplied by M.D. Resource. (Refer to Page 16 for
Technical Specifications and Page 17 for Parts & Accessories).
Note: The K Pump uses a power adaptor to isolate itself from the mains. For safe operation,
only use genuine parts supplied by M.D. Resource.
Chapter 5: Activating and Deactivating the K Pump
This chapter contains information about activating and deactivating your K Pump.
Activation
- Turn the main power switch “ON”
- Locate the control knob and rotate the speed to #3 setting.
- Depress the foot pedal to activate the K Pump. The foot pedal controls
the peristaltic Pump when the main power switch is “ON”
Note - One or both pneumatic footswitches can be used to turn the pump on and off. The
footswitches may be operated in any sequence to activate or deactivate the pumping action.
Deactivation
- Depress the Foot Pedal to deactivate the K Pump.
- Turn the main Power Switch “OFF”
To Next Page
Loading...