How to troubleshoot a pump that is not operating on M.D. Resource K Pump Medical Equipment?
If the M.D. Resource Medical Equipment pump isn't operating, first ensure the power switch is turned “ON”. Next, verify the power adapter is properly plugged into both the wall outlet and the unit's power inlet. Finally, make sure to depress the foot pedal to activate the pump.
What to do if the M.D. Resource K Pump Medical Equipment pump does not start when the foot pedal is depressed?
If the M.D. Resource Medical Equipment pump does not start when the foot pedal is depressed, it could be due to a low fluid flow. Try increasing the speed by turning the control knob clockwise. Also, ensure that the correct tubing is installed in the pump head. Contact M.D. Resource to obtain the proper tubing for the unit.
General| Manufacturer | M.D. Resource |
|---|---|
| Model | K Pump |
| Infusion Modes | Continuous |
| Accuracy | +/- 5% |
| Power Source | Rechargeable Battery |
| Display | LCD |
| Alarms | Occlusion, Low Battery |
Symbol indicating a general caution or warning.
Symbol indicating risk of electrical shock.
The specific application of the K Pump in cosmetic surgery.
General warnings and cautions for safe operation.
Essential guidelines for maintaining product quality and safety.
Steps for assembling the pump, power cord, and footswitch.
Procedure for connecting tubing and priming the pump.
Instructions on adjusting speed and activating fluid flow.
Instructions for connecting tubing, IV bag, and cannula.
Steps to turn on the pump and set it to operate.
Steps to turn off the pump and stop operation.
Instructions for cleaning the exterior of the K Pump.
Information on obtaining repair services and RMA procedures.
Details of the product warranty and limitations.
Table of common problems and their solutions for the K Pump.
To Next Page