M2I XTOP07TW - User Manual

1
Package Contents
Package contents of XTOP are below. Before using XTOP, please make sure that all of components
are in the package.
* Protection sheet is option content in XTOP04TW.
◆ XTOP Series Model Description
XTOP 08 T V - E D - E
Series Display Size LCD type Resolution S : S type A : AC power E : Ethernet
04 : 4.3” T : TFT Color LCD Q : QVGA(320*240) E : E type D : DC power + CF Card
05 : 5.7” S : STN Color LCD V : VGA(640*480) U : U type
08 : 8.4” M : STN Mono LCD S : SVGA(800*600)
10 : 10.4” X : XGA(1024*768)
12 : 12.1” W: WQVGA(480*272)
15 : 15” WVGA(800*480)
Safety Precautions
Products to safely and efficiently use it, please read through the contents of this manuals.
Precautions for the safety of using the products safely and properly will prevent accidents and risk
in advance, so please just do it.
Precautions on Disposal
When you dispose of product and battery, please treat it as industrial wastes. It can create
poisonous substances or explosion.
XTOP SERIES Installation Manual
XTOP04/07 Only

Summary

Safety Precautions

Precautions on Disposal

Design Precautions

Precautions on Wiring

Precautions on Installation

General Precautions

Battery Specification and Exchange

Serial Interface RS-232 C

COM1 RS-232 C Connector Pins and Signals

COM2 15-Pin RS-232 C Connector Pins and Signals

COM2 9-Pin RS-232 C Connector Pins and Signals

COM2 9-Pin RS-422 Terminal Pins and Signals

RS-422;485 Serial Interface

COM2 15-Pin RS-422;485 Connector Pins and Signals

COM2 9-Pin RS-422;485 Connector Pins and Signals

Ethernet Communication and Connection

USB Hardware Specification

Installation and Panel Cut Size

Panel Cut Size Specifications

Main Menu (SETUP MENU)

Communication Setup

Diagnostic Functions

Communication Diagnosis

Tests communication status, setup suitability, and parameters between PLC and XTOP.

COM Port Self Diagnosis

Checks the status of COM1 and COM2 ports for self-diagnosis.

COM Port Wiring and Setup

Mode Shifting and Screen Calibration

Shifting from RUN to Main Menu Mode

Procedure to switch XTOP Module from RUN mode to Main Menu mode for settings.

Screen Calibration Steps

Instructions for calibrating the analog touch glass if it's not responding correctly.

M2I XTOP07TW Specifications

General

Power Supply	24VDC
Operating Temperature	0°C to 50°C
Storage Temperature	-20°C to 60°C
Display Size	7 inch
Resolution	800 x 480
Touch Panel Type	Resistive
Communication Ports	Ethernet
Enclosure Rating	IP65