MAAX MXBP20 - No water flow from jets; Motor will not operate

62 Owner’s Manual
English
Problem
No water ow
from jets
Water leakage
from under spa
No air ow
from jets
Motor will
not operate
Black powder
lm around
water line
The spa will
not shut o
Usual Cause
- Pump not primed
- Adjustable jets turned o
- House circuit breaker tripped,
no power to system
- Faulty pump or motor
- Pump surges
- Slice valves closed
- Check unions & drain hoses
- Air control not open
- Jet nozzle not seated properly
- Jet nozzle missing
- House circuit breaker tripped or in
OFF position
- Improper or defective wiring or
electrical supply
- Thermal Overload Protection switch
tripped
- Wearing in of turbo/blower brushes
- Spa trying to heat
- Spa is in lter cycle
- Spa is in Standard or Ready Mode
Solution
- See Priming section
- Turn on jets
- Reset circuit breaker at
house panel
- Low water. Check level on
Weir door
- Contact dealer
- Close or tighten as necessary
- Open control - Check jet nozzles
- Inspect jets and replace
as needed
- Reset circuit breaker
- Contact dealer
- Auto reset after motor has
cooled. Contact dealer if
motor continues to cycle
- Will disappear after use
- Check ‘Set Temperature’ in
Standard Mode
- Normal. No need to change
- Check mode setting