MacDon M1170 User Manual (English)

Other manuals for MacDon M1170

Operator's Manual528 pages

Assembly Instructions142 pages

Quick Card2 pages

Questions and Answers:

J
Jonathan MyersSep 1, 2025
Why does my MacDon M1170 Farm Equipment lack power?
- L
  Lori ClineSep 1, 2025
  If your MacDon Farm Equipment lacks power, consider these potential causes: * Ensure you're using the proper type of fuel and the recommended oil. * Service the air cleaner to address any intake air restriction. * Replace the clogged fuel filter (both primary and secondary if needed). * Clean out or replace exhaust canisters to resolve high back pressure. * Remove and check the thermostat if the engine temperature is too high or low.
S
Stephanie JacksonSep 1, 2025
What to do if lights don't light on MacDon Farm Equipment?
- C
  Carol GreenSep 1, 2025
  If the lights on your MacDon Farm Equipment do not light, start by replacing any burned-out or defective light bulbs. Check the wiring for broken wires or shorts. Clean and tighten the ground wires. Inspect the circuit breaker. Finally, replace the relay if it is defective.
K
klewisSep 2, 2025
Why does my MacDon Farm Equipment engine run irregularly?
- P
  Patricia ThompsonSep 2, 2025
  If your MacDon Farm Equipment engine runs irregularly or frequently stalls, check the following: Replace the clogged fuel filter and change the filter on the fuel tank vent line if there's an unsteady fuel supply. Drain, flush, and fill the fuel system if there is water or dirt in it. Remove and check the thermostat if the coolant temperature is low.
W
william70Sep 2, 2025
Why is there low voltage and the battery won't charge on my MacDon M1170 Farm Equipment?
- E
  Erica TaylorSep 2, 2025
  If you're experiencing low voltage or the battery isn't charging on your MacDon Farm Equipment, start by having the battery tested. Clean and tighten the battery connections. Replace the alternator belt if it is defective. Ensure the alternator or voltage regulator are properly connected.
C
Carrie SmithSep 3, 2025
What causes high oil consumption in MacDon M1170?
- Y
  youngnicholasSep 3, 2025
  High oil consumption in your MacDon Farm Equipment can be due to several reasons. Ensure you are using the recommended oil. Also, check for oil leaks around gaskets, seals, and drain plugs.
C
Christine RichardsonSep 4, 2025
How to stop excessive noise from the MacDon Farm Equipment drive system?
- H
  Heather HigginsSep 4, 2025
  To address excessive noise from the drive system of your MacDon Farm Equipment, first, remove any mechanical interference in the steering or ground speed linkage. Check the charge pressure if the brakes are binding or not releasing fully. Inspect the lines for leakage if there is air in the system. Tighten the hydraulic line clamps if they are loose, and replace worn ball joints.