Page 118
REPAIR INSTRUCTIONS
101
Figure 101 — Air Compressor Removal
Valve Cover and Spacer Removal
[213 JB]
If engine is equipped with an engine brake, a
spacer is installed under the valve cover. Longer
capscrews are used to secure the valve cover
and spacer to the cylinder head.
Refer to Figure 102 for disassembled view.
1. Remove valve covers (1) by removing six
retaining capscrews (2) from each cover.
2. Discard seals.
3. If an engine brake is installed, perform the
following:
a. Remove control wire (3) from left side
of each riser housing (4).
b. Disconnect wires at the actuator
solenoid connector.
c. Remove spacers. Discard seals.
1. Air Compressor
2. Oil Supply Tube
3. Auxiliary Shaft
4. Oil Drain Openings
5. Capscrew
5_106_00.bk Page 118 Friday, August 4, 2000 11:17 AM
BDC for engine manuals and specs
https://barringtondieselclub.co.za/
To Next Page
Loading...
