REPAIR INSTRUCTIONS
Page 157
Piston Cooling Spray Nozzle
Installation
[219 RV]
SPECIAL TOOL REQUIRED
r Two-Piece Piston Cooling Nozzle Aimer
J 39045
INSTALLATION PROCEDURE
Refer to Figure 149.
1. Using a liberal amount of lubricant, install
the elastomer sleeve (7) on the locator tube
(6).
2. Install a retaining screw (4) in the spray
nozzle bracket (3).
3. Position the spray nozzle locator tube (6) in
the cylinder block oil passage (2) and using
torque wrench J 24406, or equivalent,
tighten the retaining screw to the specified
torque, 15 lb-ft (20 N•m).
149
Figure 149 — Spray Nozzle Installation
1. Threaded Hole
2. Oil Passage
3. Spray Nozzle Bracket
4. Retaining Screw
5. Cylinder Block
6. Locator Tube
7. Elastomer Sleeve
5_106_00.bk Page 157 Friday, August 4, 2000 11:17 AM
BDC for engine manuals and specs
https://barringtondieselclub.co.za/
To Next Page
Loading...
