REPAIR INSTRUCTIONS
Page 231
241
Figure 241 — Piston and Connecting Rod Installation
10. Make sure the connecting rod is aligned with
the crankshaft journal.
11. While applying downward pressure to the
ring compression tool (1) to keep it in
contact with the cylinder sleeve as shown in
Figure 242, use a hammer handle to push
the piston (2) through the tool. Continue
pushing on the piston until the top ring has
passed into the cylinder sleeve.
1. Connecting Rod Assembly
2. Piston Ring Compressor Tool
3. Cylinder Block
5_106_00.bk Page 231 Friday, August 4, 2000 11:17 AM
BDC for engine manuals and specs
https://barringtondieselclub.co.za/
To Next Page
Loading...
