Page 42
DESCRIPTION & OPERATION
Some characteristics of the E-Tech™ cylinder
head are not visually evident, but are still
significant (Figure 44). They include the following
listed items:
r Push rod holes are angled at four degrees
due to outboard location of camshaft.
r Large nozzle sleeve diameter to
accommodate 22-mm nozzle holder
assembly.
r Water-jacket casting designed to improve
coolant flow.
r Lower exhaust stud holes intersect with
push rod holes; upper exhaust holes may
intersect as well. This requires that all
exhaust studs be sealed at installation to
prevent oil weepage.
E-Tech™ and E7 cylinder heads cannot be
interchanged because of the differences in the
machining.
44
Figure 44 — Cylinder Head and Cover
5_106_00.bk Page 42 Friday, August 4, 2000 11:17 AM
BDC for engine manuals and specs
https://barringtondieselclub.co.za/
To Next Page
Loading...
