DC16 Owner’s Manual
15
Other Dante Routing
Perhaps you recall that Dante 1-29 had no default patching. That’s because they are available for a variety
of other purposes. You have multiple controllable options for routing and where they’re routed. We have
addressed three possible ways to record shows, including:
• DL32R USB output to hard drive
• DL32R USB output to laptop
• Stereo recording to iPad
But there is a fourth option, though, which is Dante routing to other recording equipment. There are
two steps to follow before you can start recording. The rst step is to set up Dante routing via Dante.
Most engineers prefer a 1-to-1 setup. In other words, Dante 1 to Mic Pre 1, Dante 2 to Mic Pre 2, etc.
See below for a screenshot of what this would look like in Dante.
To Next Page
Loading...
