1.5 INITIAL MODE FOR MAKER (C MODE)
This system has an Initial Mode for Maker.
Items and contents for changing are as follows:
㧖The content of setting, once established, will be saved in memory,
requiring no more setting for each work.
1. Retrieving the screen for initial mode for maker:
With the system power remaining turned OFF, while holding I and L
buttons pressed, continue to press F button until the screen of initial
mode for maker appears (For about 2 seconds).
After “MAEDA RADIO REMOTE CONTROL” having showed up.
”C MODE (Initial Mode for Maker)” appears, before the prompt for
password “PASS WORD 0000” comes up.
Each digit corresponds to buttons as shown above.
Operate each buttons to enter
[2FC6], before pressing D button.
Note:
㨯 Be sure to turn OFF the main switch at receiver before starting to operate the initial mode.
㨯 Before starting to change the setting, always make sure that “C MODE (Initial Mode for Maker)” has appeared on the LCD.
162
To Next Page
Loading...
