44
Selecting Time Display
Your Magellan receiver can display time in one of three formats: local
24-hour (military), local 12-hour (AM/PM), or UT (Universal Time or
Zulu). The default Time Display is LOCAL AM/PM.
MENU
Highlight
SETUP
Press ENTER
Highlight
TIME FORMAT
Press ENTER
Use
UP/DOWN ARROWS
to select LOCAL AM/PM,
LOCAL 24HR, or UT
ENTER
If either local time format is
selected, use the
ARROW KEYS
to modify the displayed time
ENTER
If the receiver does not have a computed position fix the receiver
displays a warning to alert you that an initial time has not been
set in INITIALIZE. After inputting an initial time you may change
the format that time is displayed in.
Setting Velocity Averaging
As you are travelling with your receiver on you may notice fluctuations
in the velocity displayed. Like elevation, velocity is very susceptible to
Selective Availability. Velocity Averaging will minimize this effect by
displaying an averaged speed measurement. You have three options to
choose from: OFF (no averaging) would be used where you require
rapid updates of velocity: 20 SECONDS would be selected where rapid
updates of velocity are not essential, generally at fairly low velocities; or
60 SECONDS where immediate velocity information is relatively
unimportant, such as a long journey at a constant speed. The default is
OFF.
MENU
Highlight
SETUP
Press ENTER
Highlight
VELOCITY AVG
Press ENTER
Use UP/DOWN ARROWS to
select OFF, 20 SECONDS,
or 60 SECONDS
ENTER
Setting Speed Units
SPEED UNITS allows you to select the unit of measure for speed
measurements. You may choose from KNOTS, MILES/HR or KM/HR.
The default is KNOTS.
MENU
Highlight
SETUP
Press ENTER
Highlight
SPEED UNITS
Press ENTER
Use UP/DOWN ARROWS
to select KNOTS, MILES/HR,
or KM/HR
ENTER
To Next Page
Loading...
Need help?
General