Magicard 300 Series - Printer Error Codes: Film Type and Removal Issues

ID Card Printer – User Manual
33
4:24
While moving the card from the mid sensor to the
standby position, it took too long for the mid sensor
to unblock.
5
OUT OF FILM
5:0
While moving a dye panel edge from the dye sensor
to the printhead, it took too long for the tacho
wheel to move the required amount. The film has
probably either run out or snapped.
Check dye film is fitted and not expired. Also check
the Film is not torn.
5:1
While advancing to the next dye panel, it too long
for the next panel boundary to be detected.
5:2
It took too many attempts for the printer to find a
particular panel of dye film (possibly because the
dye sensor needs calibration).
5:3
A valid dye film RFID tag was found, but no physical
ribbon could be detected while trying to take up the
film slack.
5:4
A valid dye film RFID tag was found, but there were
no shots remaining.
5:5
After printing a card, the printer was unable to
decrement the number of remaining prints on the
dye film RFID tag.
5:6
While advancing the dye film, the printer detected
the end-of-film marker.
Check dye film.
5:7
While moving the dye film, too great a time elapsed
between tacho sensor counts. The film has probably
either run out or snapped.
Check dye film.
5:8
While trying to take up the film slack, no tacho
pulses were observed within a reasonable amount
of time.
6
WRONG FILM TYPE
6:0
The fitted dye film had an invalid RFID tag. Either
the tag was not programmed correctly or there is a
Try a new dye film.