Magicard 300 Series - Printer Error Codes: Flip and Invalid File Issues

ID Card Printer – User Manual
35
8:2
While initialising the cam and having detected the
leading edge of the cam pulley flag, it took too long
to detect the trailing edge of the flag.
8:3
While moving the printhead cam to the open
position, it took too long to detect the leading edge
of the cam pulley flag.
9
FLIP ERROR
9:0
While initialising the flipper, it took too long to
detect the start of the blocked region of the flange.
9:1
While initialising the flipper and having detected the
start of the blocked region of the flange, it took too
long to detect the start of the unblocked region (the
start of the slot).
9:2
While moving the card backwards to feed into the
flipper and having seen the card arrive at the mid
sensor, it took too long for the mid sensor to
unblock.
10
INVALID FILE
10:0
The printer received a print job. The side number
specified for one of the sides of the image data was
invalid. This probably means the print job file was
corrupt.
10:1
The printer received a print job. The format
specified for the image payload was not supported.
If updating the firmware does not fix this, it may be
that the print job file is corrupt.
10:2
The printer received a print job containing magnetic
track data. One of the tracks specified an invalid
track number.