28 Channel Setup
Although your System may automatically memorize the channels you
receive when you turn it on for the first time, you can set up the
channels again.
1
Press VCR, then press DISC/MENU so the main menu
appears.
2
Press o or p to select CHANNEL SET UP. Then,
press B.
3
Press o or p to select AUTO SET UP. Press B.
4
AUTO SET UP will flash while the System sets up the available
channels.When setup is complete, the lowest available channel
will appear on the TV.
Now when you press SKIP i /CH o or SKIP j /CH
p, you will scan only through available channels.You still can
select any channel using the Number buttons.
• You cannot program channels if
you are using a Cable Box or
Satellite Receiver.
• If you have an antenna, channels
2-69 will be possible. If you have
Cable TV, channels 1-125 will be
possible.
• To stop Channel Setup, press
DISC/MENU while AUTO SET UP
is flashing.
Helpful Hints
To Next Page
Loading...
Need help?
General
