IMPULSE®•G+/VG+ Series 4 Analog Monitor Installation Manual
August 2011
1-6
3. Receiving
Please perform the following tasks upon receiving the option:
• Inspect the option for damage. Contact the shipper immediately if the option appears damaged
upon receipt.
• Verify receipt of the correct model by checking the model number printed on the option
nameplate (refer to Figure 1 on page 7 for more information).
• Contact your supplier if you have received the wrong model or the option does not function
properly.
Option Package Contents
Tools Required for Installation
• A Phillips screwdriver (M3 metric / #1, #2 U.S. standard size) is required to install the option.
• A straight-edge screwdriver (blade depth: 0.015” [0.4 mm], width: 0.098” [2.5 mm]) is required to
wire the option terminal block.
• A pair of diagonal cutting pliers.
• A small file or medium-grit sandpaper.
NOTE: Tools required to prepare option cables for wiring are not listed in this manual.
Description: Option Ground Wires Screws (M3)
Installation
Manual
--
Quantity 1 2 3 1
To Next Page
Loading...
