What to do if there is no change in output between wet gap or dry gap in Magnetrol Switch?
If you observe no change in output between a wet gap and a dry gap on your Magnetrol Switch, check first to see if the transducer gap is plugged with solids. Also check for dense foam in the gap.
How to troubleshoot one flash of the Fault LED on Magnetrol Switch?
If the Fault LED on your Magnetrol Switch flashes once, it indicates a problem with the transducer, piezoelectric crystals, or the interconnection wiring. Check all wiring inside the housing to ensure all wires are secure in their respective terminal blocks and that all terminal block screws are fully tightened. If all wires are secure, a replacement transducer may be needed, so contact the factory.
What to do if the LED flashes twice on my Magnetrol Echotel 962 Switch?
If the LED on your Magnetrol Switch flashes twice, it indicates an issue with the electronics module. Contact the factory for a replacement electronics module.
To Next Page
General
